Flue gas heat exchangers for hot water boilers

Components

Flue gas heat exchangers for hot water boilers

With the effective recovery of flue gas heat, you can save up to 15% on fuel and, at the same time, reduce emissions. A flue gas heat exchanger is part of the standard equipment for energy-optimised and environmentally friendly boiler operation.

Effective heat recovery and reduction of flue gas losses
Maximum efficiency gain when using condensing technology
Fuel savings of up to 7%, or up to 15% when using condensing technology
Intelligent control for a long service life and high level of efficiency
Compactly integrated into the boiler or as a stand-alone version for simple retrofitting

Benefits

Effective waste heat recovery

The flue gas flows at the boiler outlet inherently have heat potential at a high temperature level. A flue gas heat exchanger is great to use in order to prevent unnecessary flue gas losses. This efficiency component extracts heat from the hot flue gas and, in return, preheats return water.

Maximum efficiency gain when using condensing technology

If a separate water circuit is available, the use of condensing technology can be meaningfully supplemented. A stainless steel condensing heat exchanger partially reduces the flue gas temperature to below the dewpoint – the flue gas condenses. The condensation heat that is released preheats the separate water circuit.

High fuel savings up to 15%

The effective use of the recovered waste heat allows for fuel savings of up to 7%. When condensing technology is used, savings of up to 15% can even be achieved. Thanks to the significantly lower fuel costs, the flue gas heat exchanger usually amortises within a short time.

Intelligent control for a long service life and efficiency

In conjunction with the controls from Bosch, the boilers can be regulated and optimally operated based on the load of the consumers. Controlling the system guarantees a continuously high level of efficiency and a long service life.

Compactly integrated or easy to retrofit

The integrated variant of the flue gas or condensing heating exchanger is installed in the exhaust chamber ex works as part of the boiler, is connected on the water side and is ready for immediate use. Also available as a ready-to-connect stand-alone variant with optional bypass – recommended when using dual firing.

Language select